The main cause of the error ' Something went wrong ' in Office 2013 is because the Microsoft Click to Run service has not been activated yet . When this service is disabled on the system will cause some errors, including the error ' Something went wrong '.
To fix the error, simply activate Microsoft Click to Run service and finish.
The process of fixing ' Something went wrong Error 1058-13 ' error on Office 2013 is quite simple and you don't need to install any 3rd party software. Follow the steps below:
Step 1 :
Press the Windows + R key combination to open the Run command window. On the Run command window, enter cmd and press Enter to open the Command prompt window.
Note :
Make sure you open the Command Prompt under Admin.
Step 2 :
On the Command Prompt window, enter the following command and press Enter:
sc config clicktorunsvc start = auto
Step 3 :
Now on the screen you will see the ChangeServiceConfig SUCCESS message as shown below.
Step 4 :
Next enter the following command into the Command Prompt window and press Enter:
sc start clicktorunsvc
Step 5 :
The above command will activate service Microsoft Click to Run on your computer and error Something went wrong will no longer exist.
Good luck!