Steps to fix the error that the computer does not recognize USB Boot

Then refer to the following article to learn 5 simple and most effective ways to fix the computer error that does not recognize USB Boot!

1. Check if the USB is damaged

First of all, you need to check if the USB is damaged, this is the first thing to do to determine the cause of the error that  the computer does not recognize the USB .

You just need to plug the USB into another computer, if there is no error, the USB is completely normal. This means that the old computer has a  damaged USB port  or a system error occurs  . If the USB port is damaged, it is best to bring the device to  a reputable repair center  for support. And if the machine has a system error, you can refer to the ways the article introduces below.

In case you plug it into another computer and still have the error, it may be because the  USB is damaged . So you should buy   another USB at reputable stores like  Mobile World  and then recreate the USB Boot.

2. Restart the computer

When the computer fails to recognize USB Boot, the simplest fix you can think of is to  restart the computer . This action has the role of re-running the faulty software, from which it is possible to fix the initial errors, such as not recognizing USB Boot.

3. Try plugging the USB in the back of the case

If you have an error that does not recognize USB Boot on your computer, you can try plugging in USB in  the ports behind the case  instead of the front to fix the above situation.

4. Restart BIOS

-  Step 1 : On the BIOS menu move the blinking cursor with the arrow keys to the Reset button   (also known as:  Reset to default ,  Load factory defaults ,  Load setup defaults ,  Clear BIOS settings ,.) > Press  Enter  > Select  Yes .

-  Step 2 : Restart the computer and then try to plug the USB again.

5. Disable Disable Secure Boot

-  Step 1 : Start the computer in BIOS mode.

-  Step 2 : Turn off Secure Boot.

At the Security  tab  select  Secure Boot Menu .

Use the up and down arrow keys and the Enter key to select  Secure Boot Control .

Select  Disabled  on the right side to turn off Secure Boot.

Press the F10 key   on the computer keyboard > Select  Yes  to save the setup process just done.

If you want to return to the original interface, just press the  Esc key  on the computer keyboard.

-  Step 3 : Turn on Boot Legacy (Launch CMS)

Use the 4 arrow keys to move to the Boot tab > At the Launch CSM line  , click on  Enabled  > Press the  Enter key . At this point, Boot Legacy mode (Launch CMS) will be turned on.

Similarly, you just need to press the F10 key   > Select  Yes  to save the settings you just made.

The above article has just introduced to you 5 simple and effective ways to fix the error that your computer does not recognize USB Boot that you can apply. Good luck!