How to set up TP-LINK WIFI

Steps to install:
1. Open Internet browser, type 192.168.1.1 (or 192.168.0.1 or tplinklogin.net) to log in. A window opens requiring login Username and Password

- We flip the product up to see below with Username and Password login
- Username:  admin
- Password:  admin
2. A new interface window opens as shown

3. To set WiFi we choose on Wireless card as shown

4. In the  Wireless Setting
- Wireless Network Name : to name the WIFI
- Region : select the name of the country you want to install normally to  Unitted States to




avoid  limited waves - Channel : Select Auto or select a channel that does not coincide with network channels around - Mode : for 11bgn mixed - channel Width : select Auto - Max Tx rate: Select the highest level -  Enable Wireless Router Radio : we select  an area  on
- Enable SSID Broadcast : we built in to the current (Seeing ) WiFi name,  if unchecked then
WiFi name will be hidden, so when connecting we have to type the name of WiFi (this is used to name
WiFi).
- Enable WDS Bridging : this function is usually unchecked if it is used to use this function
we have a separate article on how to install WDS
- Done  SAVE

5. In the Wireless Security  section  shown below

- We choose to tick WPA / WPA2-Personal
- Version:  select Automatic
- Encryption:  select Automatic
- Password: we type the WiFi pass we want to install here (pass from 8 to 63 characters)
- Done  SAVE

6. Set up Ruoter WIFI to plug Internet source into WAN
- Network port to LAN to change  IP Address from the  different layer with the network you
want to install WiFi here, we  only need to  differ from the last second index
- Eg IP Network system: 192.168.1.1, the  IP Address  changed to: 192.168.x.1 here x # 1. in
here alone changed to 192.168.100.1
- Done It  SAVE

- Network select WAN (image below)

- WAN Connection Type:
+ Select  Dynamic IP : If the network system is using


Dynamic IP level and when connecting the Internet cable to the WAN port on the product, the system must provide an address to the WiFi Router like the picture above - Done  SAVE
+ Chon  Static IP : If the network is using the Static IP level (shown below).
We must enter the parameters: IP Address, Subnet Mask, Default Gateway, Primary DNS
like a computer in the network. (Note that the IP Address must check must not be
duplicated with other devices on the network)
- Done  SAVE

- Choose  PPPoE / Russia PPPoE : (below picture)

-Only select this function when we configure the Modem in Bridge Mode
or use directly with optical transmission line via Optical Converter:
- User name and Password: Enter the correct user name and password provided by the network
- Connect Automatically: tick here to connect automatically
- Done we  SAVE

7. Set up Ruoter WIFI to plug the Internet into the LAN port
- Firstly, we go to the LAN folder (picture below)

- IP Address: Change with the network layer of the system (Ex: network system
192.168.1.1 we change the IP Address to 192.168.1.x with x # 1 and must not match the IP of
other devices in the system Network)
- Subnet Mask: To resemble the system being used
- Finish going to DHCP folder:
+ DHCP Server: Select the Disable checkbox as shown below
- Done  SAVE

'Good luck'