Tips to increase copy speed for USB

In this article, Tipsmake will show you how to increase copy speed for USB.

1. Plug in the correct USB 3.0 port or higher

USB technology has now grown much stronger and most USB storage devices support USB 3.0 technology or higher. However, to enable USB 3.0 technology, you also need a supported computer system. Most motherboards from the past 3 years - ie since 2017 have been equipped with USB 3.0 to improve data transfer speed.

Unlike USB 2.0, USB 3.0 technology has 10 times the transfer speed – up to 600MB/s. This means that the USB Copy speed will be increased by 10 times (under the right conditions).

To use USB 3.0 technology, you do not need to install any software or tools. You just need to connect USB 3.0 to the correct USB 3.0 port on your computer. Most manufacturers will mark the USB 3.0 port with a distinct prominent color such as: Blue, blue, red . The default black USB ports are USB 2.0 as usual.

2. Plug the USB into the rear connector (desktop)

If you do not know, the entire I / O (Input / Output) area behind the desktop will be soldered to the motherboard and their speed is very stable. Meanwhile, the front I/O ports belong to the case and they are connected to the motherboard by a wiring system. According to tests, the speed of USB ports soldered to the motherboard is always faster than ports using wires from the case.

3. Updates Driver for USB

All electronic devices have drivers so that they can be connected to the computer and work stably. Driver updates also directly affect the Copy speed of USB, even fast or slow speed is also due to Driver. If your USB uses old drivers, their performance will also be significantly reduced.

Step 1: You open MenuStart and enter Device Manager to open.

Step 2: Then, open the Disk Drives section to see all connected storage devices on the computer. You find the name of the USB and Right-click to select Update Driver.

4. Using the Tera Copy tool

Tera Copy is a software that helps to increase the speed of copying between storage devices on the computer. Copy speed when using Tera Copy software is significantly improved and you can easily see it. The software has a light capacity, works stably on all computer platforms and supports all different types of data copying, so you can use it with peace of mind.

5. USB High Performance Setting (Format USB)

By default, your USB setting level is only in Quick Remove - normal mode, not high performance. To enable the high performance feature, proceed as follows:

Step 1: First, open This PC and right-click on the USB to select Format…

Step 2: When Format, you set the parameters as shown below and select Start to start.

Step 3: When the USB has been formatted, right-click the USB and select Properties.

Step 4: You find the name of the USB and select Properties to open the settings.

Step 5: The USB Properties window appears, select Change Settings to change the internal settings.

Step 6: Now, select the Policies section and turn on the Better Performance feature.

However, when you enable this feature, you must remove the USB properly. This means that before unplugging the USB, you must right-click and select Eject first.

In this article, TipsMake has shared with you how to increase Copy speed for USB devices most effectively. Have a nice day!