How to Repair a Scratched or Finger Printed Monitor Screen

Here is a simple way to fix a smudged or scratched monitor. It is necessary to have a clean display surface before attempting scratch repair. If you have scratches, avoid rubbing residues into them during cleaning. *Never use abrasive...

Method 1 of 3:

Cleaning Smudges and Other Residues

  1. If you have scratches, avoid rubbing residues into them during cleaning.
  2. Never use abrasive solutions
  3. Never use solvents other than water on screens with ARAG coating/film.
  1. Picture 1 of How to Repair a Scratched or Finger Printed Monitor Screen
    Take a soft cloth and wet a corner. (Do not use tap water, as it can leave a deposit or streaks from the mineral content - use Deionized water instead!)
  2. Picture 2 of How to Repair a Scratched or Finger Printed Monitor Screen
    Gently wipe the screen in circular motions while the computer or TV is off.
  3. Picture 3 of How to Repair a Scratched or Finger Printed Monitor Screen
    Wipe it in up and down direction across the screen.
  4. Picture 4 of How to Repair a Scratched or Finger Printed Monitor Screen
    Use the dry side of the cloth to dry it in circular motions.
  5. Picture 5 of How to Repair a Scratched or Finger Printed Monitor Screen
    Repeat if necessary.
Method 2 of 3:

Fine Scratches in ARAG coating (most CRT and all LCD)

  1. Windex, Brasso, or any other solution which contains ammonia, or any other solvent including acetone, will damage ARAG (anti reflective , anti glare) coatings or films.
  2. Never use abrasive solutions or solutions containing solvents on screens with ARAG coating/film.
  3. Few CD/DVD repair fluids can be used to fill or smooth over small scratches or scrapes in the plastic-like first layer of anti glare films. This is because some fluids contain solvents and/or abrasives.
  4. You can also use Pledge or some similar wood polish: It will fill in the scratches on computer monitors or CD's. However, it will leave discoloring blemishes, often more objectionable than a scratch. Petroleum jelly has the same effect, and is much harder to remove. Plastic model glue has irreversible negative effects.
  5. Damaged ARAG films can be peeled off, and new ones applied. Operating without an ARAG film will reduce contrast, alter gamma, and therefore distort picture of display unless adjusted to compensate.
    Picture 6 of How to Repair a Scratched or Finger Printed Monitor Screen
Method 3 of 3:

Scratches Deeper than Coating or On Non-Coated CRT (rare)

  1. Picture 7 of How to Repair a Scratched or Finger Printed Monitor Screen
    If applicable,peel off, or scrub away, ARAG film. This is irreversible, make sure you can buy replacement ARAG film.
  2. Picture 8 of How to Repair a Scratched or Finger Printed Monitor Screen
    Proceed with usual abrasive techniques (buffing). Glass repair resins may be more effective for very deep scratches.
  3. Picture 9 of How to Repair a Scratched or Finger Printed Monitor Screen
    If applicable, apply new ARAG film. Make sure the new film is similar in properties to the original. Be sure to check your gray scale tracking and adjust the display as necessary to avoid color and luminance distortion due to varied transmittance of new coating.
Update 04 March 2020
usefilmscratches

You should read it

Maybe you are interested

Category

System

Mac OS X

Hardware

Game

Tech info

Technology

Science

Life

Application

Electric

Program

Mobile