Cause and remedy error on hot and cold water plants

Has your home water heater ever encountered an error such as water reflux, water leak, cold / hot water or machine noise . yet? If there is such a situation, please go to find out the causes and find ways to fix these incidents in time.

4 common mistakes on hot and cold water plants and how to fix them

1. Water is refluxed on the pile of water tank

The hot and cold water plant is operating normally, naturally reflecting the water on the pile.

Cause: Do   float switch, buoy system is broken or there is a problem causing the pump to not turn itself off, causing water to flow up.

Remedy: You need to check the float switch or buoy system to see if it is broken. If it is necessary to buy replacement parts promptly.

2. Water leaked

Reason:

1. Hot and cold water leaking out of water may be broken by valves or connectors, not tightened or loose.
2. Because magnesium bars are corroded and corroded into the shell, water leaks out.

How to fix:

1. Please check whether the valves or fittings are broken and have been screwed up or not. If damaged, you need to buy replacement valve or fitting accessories. If loose, tighten them at.
2. In case of corrosion of magnesium bars, you need to call your service center to have a technician come to you.

3. Water is not hot or the water is not cold

Reason:

- When the water is not cold:

1. Because the cold switch has not been turned on.
2. Due to Block refrigerant leaking essence, Fill filter damp clogged, Wiring leads down Block and cold sensor of the machine is broken.

- When the water is not hot

1. Because the water heating switch does not turn on.
2. Because the float is hot, the control circuit is broken or the tap is hot.
3. Due to the user has not opened the safety lock of hot water faucet.

How to fix:

- When the water is not cold:

1. Please check if the cold water switch on the back of the device is turned on, if not, turn on the switch.
2. Where Block leaking lip, Moisture filter filler is blocked, wiring leads down Block and cold sensor is broken you need to call the service center for assistance.

- When the water is not hot:

1. When checking if the hot water switch is not turned on, switch the switch again.
2. In case the float switch, the control circuit is broken, the water intake switch is blocked, it is necessary to purchase accessories to replace it.
3. Check that the hot water safety lock has been opened, if not, turn it aside to open the hot water tap.

4. Hot and cold water plants have a great noise when operating

Reason:

Because the machine is placed on an uneven surface or the water touches other objects, when it causes friction, noise will result.

How to fix:

You check the stand to see if it is firmly placed on a flat surface. When placing hot and cold water plants, make sure the water plants do not touch any device.

When placing hot and cold water dispenser, it is necessary to be at least 15cm from the wall to create a fresh air to help the water plant drain heat better, for longer use durability.

In order to help the hot water plant become more durable, in addition to using water plants properly, you need to buy hot and cold water plants from genuine brands such as Sunhouse hot and cold water plants, FujiE hot and cold water plants, Kangaroo hot and cold water plants, Midea hot and cold water plants, KoriHome cold and hot water plants . are less susceptible to damage and when damaged, they can easily buy replacement parts.

These are the most common or most common errors in hot and cold water plants. Hopefully this article will help you find the cause and fix it in time to increase the durability of the product and help use water plants more safely.