Instructions on how to wrap beautiful headphones without getting tangled

In order to meet the demand of enjoying the music of young people as well as to avoid noise and affect the people around, the wired headphones are designed compact is the appropriate choice. The advantage of wired headphones is the stable signal transmission capability, integrating multiple control technologies directly by buttons on the line. And there is no need to charge the battery for use as wireless headsets on the market today. However, this advantage is also the biggest disadvantage of wired headphones. Because the headset wire is too long and cumbersome after listening, we often have the habit of curling it and stuffing it into a bag. It is this habit that inadvertently causes the headphones to be affected, causing them to be more quickly damaged, as well as being confused during the next use. So to overcome this situation, the following article will guide you how to wrap the headset, the beautiful cable is not tangled. Please follow us.

Some small note before wrapping headphones

For instructions on how to wrap this tangled headset, users should note some information as follows. With headphones that are designed to be anti-tangled, users just need to wrap the wire in a finger so that it is neat and stored in the pocket or desired location. Conversely, with a normal headset, users should wrap it gently, with sufficient force, not tightening too much, which leads to a long period of winding during the wrapping process. In addition, users should also limit the ear-wrap, except in cases where it is necessary to move far away, or stow it to easily store it for a long time to avoid more rapid damage.

1. Wrap the image headset number 8

Step 1:

First, to wrap the headphone cord or cable you need to completely debug before wrapping.

Step 2:

Wrap the headphone ring around 4 fingers as shown on the picture.

Note: for headphones, the user should start from the position of the two headphones so that it can be easily fixed after wrapping.

Step 3:

After wrapping up the headphone strings, leave a string of wires to wrap around, fixing the piece you just made. Finally, you just need to thread the wire through the circle of the wrapped wire to secure the fixed rings without slipping. Pull the cord through the hole and tighten it.

2. Anti-tangled headset with spring wire

Back in the past we were so familiar with colorful springs, with these strings, after wrapping it in the headset it would prevent your headphones from being tangled and protected by wires. this spring. The method is very simple, you just need to buy spring wire, then wrap the cable to protect them.

3. Wrap on the hard card

First, you need to get yourself a hard card such as an ATM card, a Vip Card or a membership card that you no longer use. Then cut it out as shown above.

Next, just wrap and wrap until the rest of the line is about 3 cm from the headphone jack.

Finally, just insert the leftover string like this one to be successful.

So there are just a few simple tips like that, from now on we will no longer have to be upset because the headphones are tangled every time we use them. It is also possible to use the above methods for both the mouse, keyboard or other cables and chargers. Besides, if you have other ways, please share with us below.

Maybe you are interested:

1. "Unique" earphones make Christmas gifts for music lovers
2. Instructions for using the Bluetooth headset properly
3. Using headphones properly to prevent hearing damage