How to Speed Up, Use NoxPlayer Without Lag?

This step-by-step guide explains how to speed up, use noxplayer without lag. It covers the required setup, the main actions, and the checks that help prevent common problems.

• Speed up tips for BlueStacks emulator software
• How to increase FPS League of Legends game to play smoothly on all computers
• How to reduce lag when playing Rules of Survival on a weak configuration machine

Ensure computer configuration matches NoxPlayer

NoxPlayer is known asaLightweightAndroid emulator, capable of running on most computers, but the truth is not all. Accordingly, to be able to use NoxPlayer without jerking lag, your computer configuration must meet the following minimum requirements:

• Operating system: Windows XP, Visa 7, 8 / 8. 1 and Windows 10
• RAM: 4GB or more

To know exactly the above 2 parameters for your current computer, you can refer to the operations in the articleHow to check the configuration of the Windows computerThat was previously instructed by Network Administrator. After watching, if your computer is not eligible but still runs NoxPlayer, but there is continuous lag phenomenon, see the remediation options below.

Turn off all other programs when using NoxPlayer

One of the reasons for the shock and lag when using NoxPlayer is that you let many other software run at the same time as the Android emulator. If that is the case, of course, it cannot be prevented from overloading, and even flying out can happen. Because at this time, RAM memory is full, the computer cannot take on any more activities.

Therefore, when using NoxPlayer it is best to turn off all active software with it to improve the experience process. In addition, you should also check andTurn off apps running in theBackgroundOn Windows, because they also consume quite a bit of RAM that you do not see.

Lower the configuration in NoxPlayer

To adapt to the current computer models, configure the frame rate ratio in NoxPlayer always set to medium. However, you can completely change this default setting and lower them to the minimum to speed up the NoxPlayer emulator.

At the main interface of NoxPlayer, you select The Gear icon To access the Settings Section. Next, select Advanced Settings > in the Feature settings Section, you switch from Moderate to Low Mode. The item Graphical renderingMode changes to Acceleration mode (Directx) . The bottom part is Frame , please drag back to level 30 FPS .

Change the settings, select Save settings And restart the NoxPlayer software for the changes to take effect.

Remove excess tabs in multitasking interface

NoxPlayer's multitasking feature is great to help users run several different games or apps simultaneously on a computer screen. However, its drawback is that the software becomes more sluggish than usual if too many tabs run together. So for NoxPlayer to run smoothly, clean up the tabs that are not really necessary by clicking on the multitasking icon and dragging it away.

Make the most of the power of graphics cards

This operation will vary depending on the different graphics card but the same idea is the same. You access the settings of the graphics card and move Performance to a higher level. For example, for AMD users, it is located in AMD Catalyst Control Center .

NVIDIA users can find it on the NVIDIA control panel. From the main screen interface of your computer, Right-select > select NVIDIA Control Panel .

Next, select Adjust image settings with preview > Tick The 3rd line Use my preference emphasizing And move the switch to Performance. Finally, select Apply To finish.

Enable Virtual Technology (VT) setting

This step will significantly speed up the NOX emulator. Most computers have VT but are turned off. If your computer also has this setting, turn it on. The computers have different ways to turn on in the BIOS settings section when starting the computer, then press F10 to save and exit. There are VT machines displayed right in the configuration section, sometimes located in other locations and sometimes hidden in more advanced settings.

Set up Nox player

If NOX is stuck in the Niantic loading screen, you can fix it by going to NOX Settings > Advanced > DirectX.

Hope you are succesful.