Use a damp sponge to clean the inside of the oven. Because non-stick furnaces are constantly self-cleaning, there is no need to heat up at first. Make sure the oven is cool when you clean it.
Avoid using hard cleaners or strong cleaners because it can scratch the oven's non-stick glaze.
If necessary, use vinegar and water to clean them.
Step 3: Clean the trays / blisters
Rub these blisters vigorously with soapy water. Rinse with clean water and dry. Then put it back into the oven.
Conventional oven
Step 1: Remove the trays / grills
Put them in pots with pre-wash dishwashing liquid and soak them there.
Step 2: Prepare detergent
Mix 1 liter of water with 4 spoons of baking powder (56.7 g) baking soda or NaHCO3 and pour into a spray bottle.
Shake the spray evenly to dissolve the baking soda powder with water.
Step 3: Spray the cleaning solution into the oven
Spray the detergent solution onto the oven wall. Pay attention to the location of many adhesives or burnt, spray the solution until the carbon coal layer dissolves.
For stoves that are heavily fouled, increase the proportion of baking powders to be able to dissolve them more effectively.
Step 4: Wait about an hour
After spraying the cleaning solution, you should wait at least an hour and check if the dirt has peeled off.
If not, continue spraying the solution into that location and wait another hour.
If they melt, proceed to the next step.
Step 5: Scan the oven
Use a curler strong enough to remove the cohesive coal from the oven. Continue shaving until the carbon disappears.
You can wear rubber gloves if you don't want to cling to your hands.
Use more baking powder to make it easier to scan.
Finally use a small brush or brush to clean the oven.
Step 6: Spray the cleaning solution again
Continue using soda baking solution to clean the oven. Soak them for another 1 hour and then use the scrubber to remove the remaining carbon note.
Step 7: Clean the oven again with vinegar and water solution
By this time, the oven was almost clean. You can use vinegar with a vinegar solution to clean the last time. If carbon still exists, you can try 2 " last " ways below:
Use industrial oven cleaner. This chemical has a slightly unpleasant odor so you have to be careful when using it. Please read the instructions for use on the packaging.
Use ammonia solution. You can spray this special chemical into "stubborn" spots and wait for about 30 minutes then clean as the above steps.
Step 8: Clean the trays / blisters Rub these blisters vigorously with soapy water. Rinse with clean water and dry. Then put it back into the oven.
Note when using an oven
Place grease pads underneath
If you grill things that are easy to get dirty, put a grease pad underneath to catch them.
Clean up immediately after use
If you accidentally drop food into the oven wall when baking, you can clean it right away during cooking.
Sprinkle some salt on it, close the oven door and continue to grill.
After baking, turn off the oven and use a sponge with sponge to wipe immediately.
Use water with vinegar solution to wipe away the stains that cannot peel off immediately.