Common errors in freezer and how to fix

To help users do not encounter difficulties when using the freezer, TipsMake.com today will raise 7 most common errors in the freezer and how to fix errors to help users can repair the freezer in time to pull Long life for products.

Check out the common errors on the freezer and how to fix

Freezer is divided into 2 types: Freezer 1 compartment and 2 compartment freezer. However, the mechanism works the same, so the following basic errors are often encountered:

1. Freezer does not work

Reason:

1. The freezer does not enter the power because the outlet has no electricity or is not connected to the power source.
2. Freezer does not work because the voltage is unstable, too low or too high.

Common errors in freezer and how to fix Picture 1

How to fix:

1. You need to check the freezer's electrical outlet to see if it is plugged into the power source. Or use an electric tester to check if the outlet has electricity.
2. When the voltage source is unstable, users need to equip more voltage stabilizers or transformers to stabilize the power source, making the freezer more stable and stable operation.

If you have checked it carefully and not because of the two reasons above, you should call the service center or repair center to fix it in time.

2. Freezer smells bad

Reason:

1. Foods that are not well-packed lead to spoilage and decay.
2. The inner compartments of the cabinet are not clean.

How to fix:

1. When you see an unpleasant freezer, you need to check if the food is broken. If damaged, immediately remove the food from the cabinet. And remember to pack up the new food carefully next time.
2. Freezer dedicated to preserving fresh food so users need to clean the freezer regularly, periodically every 2-3 months.

3. The freezer is not cold or cold for long

Reason:

1. Open the freezer often to cause cold loss.
2. Preserving too much food is allowed.
3. Freezer is closed with thick ice.

Common errors in freezer and how to fix Picture 2

How to fix:

1. Need to minimize the opening of the freezer lid many times.
2. Arrange food properly to have a hole that helps air flow. Do not put food in the freezer beyond the allowed level.
3. When the freezer is closed with a thick layer of ice you need to proceed with defrosting and cleaning the cabinet.

4. The light in the cabinet is not bright

Reason:

1. The freezer light is broken.

Common errors in freezer and how to fix Picture 3

How to fix:

1. You need to check if the freezer is plugged into the power source. If the freezer has been plugged in, but the light is still not lit, the lamp will be damaged. In this case, you should not try to repair but call the repair center to check and replace.

5. The freezer cannot close the door

Reason:

The freezer cannot be closed due to one of the following three reasons:

1. Freezer tilted.
2. The cabinet contains too much food.
3. Packaging is stuck on the wall of the cabinet.

Common errors in freezer and how to fix Picture 4

How to fix:

1. Check that the freezer has been placed on a flat surface. If the cabinet is tilted, it is necessary to restock the cabinet.
2. Check if the packaging is sticky on the wall of the cabinet. If so, take it out.
3. If the cupboard contains too much food you need to remove it or rearrange the food properly (food should always be under the cabinet, not higher than the wall).

6. The freezer emits a loud noise

Reason:

1. Freezer set on unbalanced surface.
2. Food arrangement is not reasonable.
3. Parts of the freezer installed are not tight.

How to fix:

1. When you see a big freezer, you need to check if the cabinet is balanced. If you do not need to restock the cabinet, the cabinet will operate more smoothly.
2. It is necessary to rearrange the food to be flat but there is a gap to radiate heat evenly.
3. Check that the cabinet door or the screw of the wheel has been tightened. If not, turn them tight.

7. Freezer is watery

Reason:

1. The freezer hole of the freezer is open.
2. The cabinet or tray catches cracked or damaged water.

Common errors in freezer and how to fix Picture 5

How to fix:

1. You need to check the defrost hole to see if it is open, if you remove the valve cover and close it.
2. If the cabinet is broken, call the repair center to be repaired in time. As for the tray to catch the water, check that the tray is in place. If the tray fails, you need to buy a new water tray instead.

These are the most common errors that are encountered in the freezer. Hope this article will help you get more experience to repair freezer in time, bring high use value.